Setting Up The Dsp730 - Meridian DSP730 User Manual

Setting up the DSP730

This section explains how to set up the loudspeaker in each of
the typical applications.
Using the loudspeaker on the left of the
system
• Set the channel selector switch to Left or Centre.
In a multichannel system this applies to all loudspeakers on the
left-hand side of the room
Using the loudspeaker on the right of the
system
Set the channel selector switch to Right.
•
In a multichannel system this applies to all loudspeakers on the
right-hand side of the room
Using a single loudspeaker individually with
a TV
Set the channel selector switch to L+R.
•
If the loudspeaker is located below the display screen Centre
Elevation can be used to raise the sound image up to the
screen.
DSP730 In-Wall Digital Active Loudspeaker User Guide
• Choose between Off (lowest), Minimum, Medium, or
Maximum (highest).
The ideal setting will depend on the layout of the loudspeaker
and screen.
When the channel selector switch set to L+R Centre
Elevation can be adjusted via RS232; see RS232 control and
configuration , page 14. The setting will be retained even if the
loudspeaker is powered off.
Centre Elevation is only appropriate for loudspeakers located
below the display screen, or the mid-height point of an
acoustically transparent screen. It may be of limited benefit if the
distance between the loudspeaker and the screen is small relative
to the distance between the screen and the listening position.
Using the loudspeaker to play a mix of left
and right audio in other situations
• Set the channel selector switch to L+R.
This will play a balanced mix of left and right audio, allowing
a single loudspeaker to reproduce all the audio present in a
stereo recording. It also provides a useful option for systems
using multiple speakers where the listening area does not have
clearly-defined left and right loudspeaker positions.