Gigabyte GA-H270-HD3 User Manual page 14

_
B
S B_
B
5) SATA EXPRESS (SATA Express Connector)
Each SATA Express connector supports a single SATA Express device.
_ S
S_
_
B
_ U
_
6) SATA3 0/1/2/3/4/5 (SATA 6Gb/s Connectors)
B
The SATA connectors conform to SATA 6Gb/s standard and are compatible with SATA 3Gb/s and SATA
1.5Gb/s standard. Each SATA connector supports a single SATA device. The Intel
RAID 1, RAID 5, and RAID 10. Refer to Chapter 3, "Configuring a RAID Set," for instructions on configuring
F_USB3 F
a RAID array.
7) M2A_32G (M.2 Socket 3 Connector)
The M.2 connector supports M.2 SATA SSDs and M.2 PCIe SSDs and support RAID configuration through
the Intel
an M.2 SATA SSD or a SATA hard drive and can only be used to build a RAID set with UEFI. Refer
to Chapter 3, "Configuring a RAID Set," for instructions on configuring a RAID array.
Follow the steps below to correctly install an M.2 SSD in the M.2 connector.
Step 1:
Use a screw driver to unfasten the screw and nut from the motherboard. Locate the proper mounting hole
for the M.2 SSD to be installed and then screw the nut first.
Step 2:
Slide the M.2 SSD into the connector at an angle.
Step 3:
Press the M.2 SSD down and then secure it with the screw.
B S_
B
S _
U
B_
SATA3 5 3
4 2
1
7
7 1
To enable hot-plugging for the SATA ports, refer to Chapter 2, "BIOS Setup," "Peripherals\SATA
And RST Configuration," for more information.
Please note that an M.2 PCIe SSD cannot be used to create a RAID set either with
Chipset.
®
110 80 60
Select the proper hole for the M.2 SSD to be installed and refasten the screw and nut.
S _
F
S _
_ 0
SATA3 1 0
7
1
_ F
U
B_
_ 0 F
42
- 14 -
B_
S _S
_
S
S
Chipset supports RAID 0,
®
B_
Pin No. Definition
USB 0_ B
1 GND
2 TXP
3 TXN
4 GND
5 RXN
6 RXP
7 GND
_
_
B_
USB 0_ B