Printing Does Not Start - Canon G2010 Series Online Manual

Printing Does Not Start

Make sure printer is turned on.
Check1
If not, make sure the printer is securely plugged in and press ON button to turn on.
The ON lamp flashes while the printer is initializing. Wait until the ON lamp stops flashing and remains lit.
Note
• If you are printing large data such as photos or other graphics, printing may take longer to start. The ON
lamp flashes while the computer is processing data and sending it to the printer. Wait until printing starts.
Make sure USB cable is securely plugged in to printer and computer.
Check2
When the USB cable is securely plugged in, check the following:
• If you are using a relay device such as a USB hub, disconnect it, connect the printer directly to the
computer, and retry the printing. If printing starts normally, there is a problem with the relay device. Contact
the vendor of the relay device.
• There could also be a problem with the USB cable. Replace the USB cable and retry the printing.
If printing from a computer, delete jobs stuck in print queue.
Check3
Deleting the Undesired Print Job
Is your printer's printer driver selected when printing?
Check4
The printer will not print properly if you are using a printer driver for a different printer.
Make sure "Canon XXX series" (where "XXX" is your printer's name) is selected in the Print dialog box.
Note
• To make the printer the one selected by default, select Set as Default Printer.
Check the size of print data.
Check5
If the print data is large, part of image data may be cut off and printing failure may occur.
Click Print Options on Page Setup sheet of the printer driver. Then set Prevention of Print Data Loss to On in
the dialog that appears.
Important
• Selecting On for Prevention of Print Data Loss may reduce print quality.
If printing from a computer, restart the computer.
Check6
232