Turn And Lane Change Signals - Pontiac 2001 Sunfire Owner's Manual

Turn and Lane Change Signals

The turn signal has two upward (for right) and two
downward (for left) positions. These positions allow
you to signal a turn or a lane change.
To signal a turn, move the lever all the way up
or down. When the turn is finished, the lever will
return automatically.
To signal a lane change, just raise or lower the lever
until the arrow starts to flash. Hold it there until you
complete your lane change. The lever will return by
itself when you release it.
As you signal a turn or a lane change, if the arrows
flash rapidly, a signal bulb may be burned out and other
drivers won't see your turn signal.
If a bulb is burned out, replace it to help avoid an
accident. If the arrows don't go on at all when you
signal a turn, check the fuse (see "Fuses and Circuit
Breakers" in the Index) and for burned
2-38
An arrow on the instrument
panel cluster will flash in
the direction of the turn or
lane change.
-
out bulbs.
Headlamp High/Low-Beam Changer
To change the headlamps from low beam to high, or
high beam to low, pull the turn signal lever all the way
toward you. Then release it.
Flash-to-Pass
This feature lets you use your high
signal a driver in front of you that you want to pass.
To use it, pull the turn signal/multifunction lever
-
toward you until the high
then release the lever to turn them off.
When the high beams
are on, this light on the
instrument panel cluster
will also be on.
-
beam headlamps to
beam headlamps come on,