Whistler XP200i Owner's Manual page 11

NOTE:
• If the equipment or appliance you intend to operate requires
more than 150 watts of continuous power, this inverter should be
connected directly to the power source using the Hard Wire Cables
(400 watt model). Failure to do so may result in serious damage to
the power cord or to the cigarette socket lighter wiring.
• Loose connections can result in a severe decrease in voltage
which may cause damage to the wires and insulation.
• Failure to make proper porlarity connection between the
inverter and the power source will result in reverse polarity.
Reverse polarity will blow the internal fuse(s) and may cause
permanent damage to the inverter. Damage caused by reverse
polarity is not covered under the WHISTLER warranty.
• Making the connection between the Positive terminals may
cause a spark as a result of current flowing to the capacitors in
the inverter. This is a normal occurrence. Due to the potential
for sparking, however, it is extremely important that both the
inverter and the 12 volt battery be well removed from any
possible source of flammable fumes or gases.
• Failure to heed this warning could result in fire or explosion.
*Some vehicle lighter sockets or power ports may only supply 10 amps or
approximately 100 watts. If so, use the hardwire cables. Check vehicle's
owner's manual for power source fuse rating.
• XP400i watt model - If the supplied cables are too short to
allow for placement of the inverter in a desired location, the
inverter may be connected to the power source using a #8 wire,
up to 12'. Use #4 wire for longer lengths. The steps outlined
for making the connection and the related safety precautions
remain unchanged.
OPERATION
9