Advertisement
Installation Notes:
1. The RIVER Plus Extra Battery must be installed with RIVER Plus before it can be used. It cannot be used
by itself.
2. During the installation process, please pay attention to anti-static protection to ensure that there is no
static electricity from the operator or the environment. Static electricity may cause damage to the product.
3. RIVER Plus must be turned off before the installation process.
4. Tighten the screws to ensure the RIVER Plus Extra Battery is firmly attached to RIVER Plus.
5. The RIVER Plus Extra Battery is designed to be used with RIVER Plus power station only. DO NOT
connect it with a RIVER or other power stations.
Product Use:
1. DO NOT expose the product to any liquids. Do not immerse the product in water. DO NOT leave the
batteries out in the rain or near a source of moisture. Moisture in the product could cause short circuits,
component failure, fires or even explosions.
2. Never use non-EcoFlow parts. Go to http://www.EcoFlow.com to purchase new parts. EcoFlow takes
no responsibility for any damage caused by the use of non-EcoFlow parts.
3. Never install or remove the RIVER Plus Extra Battery or other modules from the RIVER Plus when it is
turned on. DO NOT plug or unplug other modules when the power of the product is turned on, other-
wise the power interface may be damaged.
4. DO NOT use the product in environments above 140ºF (60°C), it may cause fire or explosion. Using
the product in environments below -4ºF (-20°C) will severely affect the performance of the product.
Allow the product to return to a normal operating temperature before use it.
5. DO NOT use the batteries in strong electrostatic or electromagnetic environments. Otherwise, the
battery control board may malfunction and cause a serious accident during use.
6. Never disassemble or puncture the product in any way. Otherwise, it may leak, catch on fire, or explode.
7. DO NOT use the product if it was involved in a crash, accident, or a forceful jolt.
8. If the product falls into the water during use, take the product out immediately and put it in a safe
and open area. Keep a safe distance from it until it is completely dry. Never use it again and dispose of
it properly as described in the Battery Disposal section below. If the product catches fire, it is recom-
mended to use fire extinguishing equipment in the following order: water or water mist, sand, fire blan-
ket, dry powder fire extinguisher, and carbon dioxide fire extinguisher.
9. DO NOT put the RIVER Plus Extra Battery in a microwave oven or in a pressurized container.
10. DO NOT allow pins, wires or other metal pieces to insert to the RIVER Plus Extra Battery case, out-
lets or controls. Metal pieces may short circuit the product.
11. Avoid collision. DO NOT place heavy objects on top of the RIVER Plus Extra Battery.
12. If there is dirt on any plug or outlet surface, use a dry cloth to clean it. Otherwise, it will cause abra-
sion and result in energy loss or inability to charge.
13. You can only connect the RIVER Plus Extra Battery to the RIVER Plus. Do not connect the RIVER
Plus Extra Battery to RIVER power station or other products. EcoFlow will not be responsible for any
losses or damages caused by failure to follow this instruction.
Advertisement
