Initialize All - Kenwood DDX3028 Service Manual

Supports the specifi cation for entering code for forcefully canceling secu-
rity using wireless remote controller when Security code is unknown (Used
Forcefully cancel
mainly by service).
Security code
∗ Can be input from any source or condition.
∗ No time out is specifi ed.
TUNER span switching Switches TUNER frequency step/span.
Memory clear Clears the backup memory and installer memory.
Used when displaying at a retailer.
q When power ON, always start with DISC source (whether or not there
is a DISC in the unit).
∗ In all cases when the power supply is turned ON, including initial
Retailer mode ON
w EJECT prohibited
∗ Ejected only when [EJECT] key is pressed and held for 10 seconds.
e Backup memory and installer memory will not function.
Retailer mode OFF Cancels the above special operation.
Service mode
1. Switching to service mode
While pressing the [TEL/AUD] q key, within 0.5sec., touch
upper left corner w of the touch panel, and then within 2
sec., touch upper right corner e of the touch panel.
2. Display specifi cations (Layer 1)
Directly touch the item to select the operation.
SYS V1000 TUN:Y
APP D2000 MON:Y
DATA V3000 TOU:Y
DISC V0065
Macrovision 0001
DivX 0001
BT V302
Span K
SYS-AREA : E DDX4
DISC-AREA : E reg : 2
S.No : 173X0021

INITIALIZE ALL

BACK
When not adjusted
TUN: N
MON: N
TOU: N
TEST MODE
power ON, power OFF → ON, ACC OFF → ON, etc., DISC source
come up fi rst.
TEMPERATURE
DVD CHECK MODE
RUNNING MODE
ERROR/DIAG DATA
SMETER LEVEL CALIBRATION
RDS TEST MODE
BT MIC TEST
BT DONGLE CHECK
FIRM UPDATE MODE
EXIT
DDX3028/3048/3058/318/4038/4038M
DDX4028BT/4038BT/4038BTM/4048BT/4058BT/418
Wireless remote controller (AUD mode)
552222777
EJECT + ATT + RST
MENU + ATT + RST
MENU + FNC + RST
MENU + RST
2-1. INITIALIZE ALL
• Initialize backup memory, installer memory, user memory.
• Initialize DISC module (Initialize to normal).
• Initialize Bluetooth module.
• Initialize user-captured wall paper area.
Clear the user-captured area of APP μ-com F. ROM and
bring back to the default condition (all black).
• Do not clear the monitor adjustment data in APP μ-com
FLASH.
• Do not clear touch panel adjustment data/ TUNER ad-
justment data/ TUNER span information/ serial number.
While executing INITIALIZE
NOW···
INITIALIZE ALL
BACK EXIT
11