Advertisement
Available languages
Available languages
Using the lock
11.
Add administrator
a.
Press the reset button (on the rear handle) for one second, the lock will make a long beep.
Add an administrator password (6-8 digits) then press the '#' key (you must add the same
b.
password twice followed by the '#' key).
c.
You will hear the 'C, D, E, F, G' notes indicating that it has been successfully added.
d.
To exit set-up mode press '*' key.
e.
Then you can add the second and third administrator.
Note:
When the lock has not been added correctly, it will make a double 'beep' sound and the LED
indicator will light up in red, this can be due to the following causes:
1. The password is very simple.
2. The password is less than 6 digits or more than 8.
3. The confirmation password was typed differently.
Add user
a.
Briefly press the reset button, the melody 'G, F, E, D, C' will indicate that you need to
verify the administrator.
b.
To verify the administrator, enter the password that has been enabled for it.
c.
After the administrator has been verified, the lock will make a long "beep". Enter the
user's password (6 to 8 digits) and then the '#' key, type the password again followed by
the '#' key.
d.
You will hear the melody 'C, D, E, F, G' indicating that it has been successfully added.
e.
To exit the set-up mode, press the '*' key.
Delete user
a.
Briefly press the '5' key followed by the '#' key, the melody 'G, F, E, D, C' will indicate
that you need to verify the administrator.
b.
To verify the administrator, enter the password that has been enabled for it, then the
lock will make a long "beep".
Enter the password of the user you wish to delete and then press the '#' key, the lock will
c.
make a long "beep".
d.
Enter the password again.
e.
The melody 'C, D, E, F, G' will be heard indicating successful deletion.
f.
To exit the set-up mode, press the '*' key.
Notes:
This operation can only delete users and not administrators.
You can only remove administrators by restoring factory settings.
24
Advertisement
