Charging The Internal Battery - Fluke 1735 Manual Supplement

1735 Users
Change #1
On page 10, prior to Basic Operation, add the following:

Charging the Internal Battery

Before you use the 1735 Logger, charge the internal battery as
follows:
1. Switch the 1735 Battery Charger to either 115V or 230V as
appropriate.
2. With the Logger power off, attach the BC1735 battery
charger to a power outlet and then to the 1735.
3. Charge the 1735 for 5 hours before using it for the first time.
4. On subesquent use, turn the Logger power on before you
connect the BC1735 Battery Charger.
This helps insure that the fast charge mode is activated. If the
Logger does not turn on due to a discharged battery, recharge the
battery for 5 hours with the Logger power off as described in
steps 2 and 3 above.
Change #2
On page 52, under EMC replace the Emission, with the
following:
Emission:
Change #3
On page 2, add the following symbol to Table 1:
-
Do not apply around or remove from the Hazardous
Live conductors
6/07
IEC/EN 61326-1:1997+A1:1998+A2:2000 class B
1
Manual Supplement