Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Caple GC100SS
Summary of Contents for Caple GC100SS
-
Page 3: Table Of Contents
Contents 1. Warnings for safety and use _______________________________ 14 2. General information _____________________________________ 15 Servicing and assistance __________________________________________________ 15 3. Installation_____________________________________________ 16 Electric connection _______________________________________________________ 18 4. Description of the hood___________________________________ 19 5. Description of controls ___________________________________ 20 Control panel ___________________________________________________________ 20 6. -
Page 4: Warnings For Safety And Use
Warnings 1. Warnings for safety and use THE PRESENT MANUAL IS INTEGRAL WITH THE APPLIANCE AND MUST HENCE BE PROPERLY MAINTAINED INTACT AND ALWAYS KEPT WITHIN EASY REACH THROUGHOUT APPLIANCE WORK LIFE. BEFORE USING THE SUCTION APPLIANCE, WE RECOMMEND READING THIS MANUAL AND ALL THE INDICATIONS IT CONTAINS THOROUGHLY. -
Page 5: General Information
Warnings 2. General information This user’s manual is an integral part of the product purchased. The user must conserve the manual correctly so that it is always available for consultation during the use and maintenance of the product. Keep this user’s manual for future reference. If the product is resold, the manual must be transferred to any subsequent owner or user of the product. -
Page 6: Installation
Instructions for the installer 3. Installation Only qualified installers are authorised to carry out the operations described below. The professional installer is responsible for appliance commissioning in accordance with prevailing standards and requirements under law. Always remember to remove plastic protections before using the appliance. - Page 7 Instructions for the installer Never use the hood if the filter is not correctly fitted! The sucked out air must not be conveyed into a duct used for discharging the fumes from devices powered with energy other than electricity. The room must always be adequately aired when a hood and devices powered with energy other than electricity are used at the same time.
-
Page 8: Electric Connection
Instructions for the installer Electric connection Prepare an omni-polar cutoff device on the power supply line of the appliance with a contact opening distance equal to or more than 3 mm, located in a convenient position near the appliance. The plug at the end of the power supply cable and the wall socket must be the same type and must comply with current electric standards. -
Page 9: Description Of The Hood
Instructions for the user 4. Description of the hood Telescopic stack Stack Hood structure Motor Control panel Metallic greaseproof filters Installation kit Halogen light... -
Page 10: Description Of Controls
Instructions for the user 5. Description of controls Control panel 5.1.1 Manual mode LIGHT BUTTON: press this button to switch on the lights and the LED inside the button turns blue. SPEED REDUCTION BUTTON: press this button to reduce the speed of the motor and the LED inside the button turns green. -
Page 11: Cleaning And Maintenance
Instructions for the user 6. Cleaning and maintenance Switch off the power supply to the appliance before starting the installation. This operation resets the count of the 40 consecutive operating hours and the ON/OFF LED turns green. Do not clean the surfaces of the appliance when they are still hot. Do not use pressure or steam spray guns to clean the appliance. -
Page 12: Replacing Bulbs
Instructions for the user Replacing bulbs Proceed as follows: prise up the protection using a small flat-head screwdriver or similar tool; replace the damaged bulb. Use only halogen lights max 20W (G4), taking care not to touch them with the hands; close the light cover (snap shut).