Problems And Troubleshooting - Cornelius Energize 2 Operating Instruction

C

11. Problems and Troubleshooting

Before looking for problems with the dispensing equipment, first check:
Is the electricity to the device interrupted?
Is the flow of water to the device interrupted?
Are the beverage containers empty?
Is the CO -cylinder empty?
2
Type of problem
Beverage too warm compressor is
running
Beverage too warm, compressor not
running
Beverage foams at a tap
Beverage foams at all taps
CO -volume in the beverage is too
2
low
Too much or not enough syrup in
the beverage
Tap just outputs concentrate Note!
Only with mechanical taps
Cause
Condenser dirty
Compressor defective
Electric control defective
Syrup stored too long
CO -pressure too high
2
All syrups enriched with CO
All beverages stored too warm
Too much beverage being dispensed
Air in carbonator
Beverage dispense rate at capacity
CO -cylinder empty
2
Valve on CO -cylinder is closed
2
Valve on pressure regulator is closed
CO -pressure too low
2
Water temperature to high
Regulator in tap is blocked
Tap is misaligned
Pressure for syrup too low or to high
Carbonator pump is not running
34
Energize proizvodna serija
Use brush to clean condenser louvers
Call service technician
Check whether the carbonator
motor is running; if
not, call service technician
Connect with fresh product
Set CO pressure
2
Connect container with fresh product
2
Check storage temp
Note out-put capacity
Bleed air
Reduce dispense rate
Change CO
Open CO
Open valve
Adjust valve to pressure
Ice bank used up, allow time to build
new ice bank
Call service technician
Call service technician
Adjust CO
Check if water feed line is open
Check if water flow pressure of 2 bar
Check if Carbonator pump is running,
if not call service technician
Remedy
cylinder
2
valve
2
-pressure
2