Advertisement
Available languages
Available languages
INSTALLATION FOR K-4404 TOILET
Setscrew
Gap Adjustment
1/8" (3 mm)
K-4404
Remove the screw on the outside edge of the locking clip. Loosen the inside screw and slide the locking clip counterclockwise
until it is clear of the plunger arm.
Remove the plunger arm by tilting the end near the locking clip up and pulling toward you.
NOTE: During the next step the toilet will flush if the water is not turned off.
Install the new plunger with plunger arm hook facing in downward direction on top of the trip arm. Place the other end
of plunger arm in the support slot. The clear plastic guard on the plunger arm should rest on the trip arm. If the clear plastic
guard on the plunger arm doesn't rest on the trip arm, bend the trip arm until the two pieces fit together properly. Bend
slightly beyond contact area to allow for spring back.
NOTE: The plunger arm hook and the trip arm should not contact each other while at rest.
Swivel the locking clip into place to hold the plunger arm in position. Do not secure with the screw at this time
Check the spacing between the top surface of the actuator and the bottom side of the plunger arm. The spacing should be
1/8" (3 mm).
If the spacing is not correct, remove the new plunger arm. Remove the setscrew at the top of the actuator with a phillips
screwdriver and adjust the height. Turn clockwise to lower or counterclockwise to raise. If spacing is correct hold the actua-
tor to keep it from turning and tighten the screw. Reinstall the new plunger arm.
Check for proper positioning between the trip arm and plunger arm. Secure with the locking clip screw.
NOTE: Turn the water back on if it is turned off.
Test the installation by slapping the trip lever HARD while watching the connection area where the trip arm and plunger
arm meet. The arm hook should prevent the plunger arm from jumping off the trip arm and disengaging. If arms disengage,
adjust the trip arm again for a better connection.
Kohler Co.
Locking
Clip
Plunger
Arm
Actuator
Air Inducer
Trip Lever
Supply
Hose
Screen
3
Actuator
Vessel
Overflow
Valve
Pressure
Regulator
B
1007324-9-
Advertisement
