To Disable A Rke Transmitter Linked To Memory - Jeep 2010 Grand Cherokee Owner's Manual

98 UNDERSTANDING THE FEATURES OF YOUR VEHICLE
To recall the memory settings for driver one, press
MEMORY button number 1 on the driver's door, or the
UNLOCK button on the RKE transmitter linked to
memory position 1.
To recall the memory setting for driver two, press
MEMORY button number 2 on the driver's door, or the
UNLOCK button on the RKE transmitter linked to
memory position 2.
A recall can be cancelled by pressing any of the
MEMORY buttons on the drivers door during a recall (S,
1, or 2). When a recall is cancelled, the driver's seat,
driver's mirror and the pedals stop moving. A delay of
one second will occur before another recall can be
selected.

To Disable a RKE Transmitter Linked to Memory

1. Turn the ignition switch to the LOCK position, and
remove the key.
2. Press and release MEMORY button number 1. The
system will recall any memory settings stored in position
1. Wait for the system to complete the memory recall
before continuing to Step 3.
3. Press and release the memory S (SET) button located
on the driver's door.
4. Within five seconds, press and release MEMORY
button 1 on the driver's door.
5. Within five seconds, press and release the UNLOCK
button on the RKE transmitter.
To disable another RKE transmitter linked to either
memory position, repeat steps 1 through 5 for each RKE
transmitter.
NOTE: Once programmed, all RKE transmitters linked
to memory can be easily enabled or disabled at one time.
Refer to "Electronic Vehicle Information Center (EVIC)/
Customer-Programmable Features" in "Understanding
Your Instrument Panel" for further information.