Jeep 2009 Grand Cherokee Owner's Manual page 301

Shifter T-Handle
4WD LOW to 4WD HI
With the vehicle at speeds of 0 to 3 mph (0 to 5 km/h),
key ON or engine running, shift the transmission into
NEUTRAL, and raise the transfer case T-handle. The
"4WD LOW" indicator light in the instrument cluster,
will flash and go out when the shift is complete. Release
the T-handle.
NOTE:
If shift conditions/interlocks are not met, or a transfer
case motor temperature protection condition exists, a
"CHECK SHIFT PROCEDURES" message will flash
from the EVIC (Electronic Vehicle Information Center).
Refer to "Electronic Vehicle Information Center
(EVIC)" in Section 4 of this manual.
Shifting into or out of 4WD LOW is possible with the
vehicle completely stopped, however difficulty may
occur due to the mating clutch teeth not being prop-
erly aligned. Several attempts may be required for
clutch teeth alignment and shift completion to occur.
The preferred method is with the vehicle rolling 0 to
3 mph (0 to 5 km/h). If the vehicle is moving faster
than 3 mph (5 km/h), the transfer case will not allow
the shift.
STARTING AND OPERATING 299
5