To Set The Alarm; To Disarm The System - Jeep 2006 Liberty Owner's Manual

28 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE
NOTE: The "Panic" and "Security" alarms are quite
different. Please take a moment to activate the "Panic"
and the "Security" modes to hear the differences in the
horn. In case one should go off in the future, you will
need to know which mode has been activated in order to
deactivate it.

To Set the Alarm

The alarm will set when you use the remote keyless entry
transmitter to lock the doors and swing gate or when you
use the power door lock switch while the door is open.
After all the doors are locked and closed, the "Sentry
Key/Security Alarm Indicator Light" (located in the
instrument cluster) will flash rapidly for about 16 sec-
onds to signal that the system is arming. During this 16
second arming period, opening any door or the swing
gate will cancel the arming. If the system successfully
arms, the "Sentry Key/Security Alarm Indicator Light"
will flash at a slower rate to indicate the alarm is set.

To Disarm the System

To disarm the system, you will need to press the "Un-
lock" button on the remote keyless entry transmitter or
turn the ignition key to the RUN position. If something
has triggered the system in your absence, the horn will
sound three times when you unlock the doors. Check the
vehicle for tampering.
NOTE: On vehicles equipped with Remote Keyless
Entry (RKE), there will not be a door lock cylinder on the
front passenger door, rear doors, or rear swing gate.
Therefore, you will be unable to disarm the system with
a manual unlock of the passenger or rear doors.
The Security Alarm System is designed to protect your
vehicle; however, you can create conditions where the
system will arm unexpectedly. If you remain in the
vehicle and lock the doors with the transmitter, once the
system is armed (after 16 seconds), when you pull the
door handle to exit the alarm will sound. If this occurs,