Tire Chains - Jeep 2005 Liberty Owner's Manual

274 STARTING AND OPERATING

TIRE CHAINS

CAUTION!
To avoid damage to your vehicle or tires, observe the following
precautions:
•
Because of restricted chain clearance between tires and other
suspension components, it is important that only chains in
good condition are used. Broken chains can cause serious
damage. Stop the vehicle immediately if noise occurs that could
indicate chain breakage. Remove the damaged parts of the
chain before further use.
•
Install chains on the rear wheels as tightly as possible and then
retighten after driving about
•
Do not exceed 30 mph (48 km/h).
•
Drive cautiously and avoid severe turns and large bumps,
especially with a loaded vehicle.
•
Do not drive for prolonged period on dry pavement.
•
Observe the tire chain manufacturer's instructions on the
method of installation, operating speed, and conditions for use.
Always use the lower suggested operating speed of the chain
manufacturer if different than the speed recommended by the
manufacture.
⁄ mile (0.8 km).
1
2
Tire chains that are recommended for this vehicle are
listed below:
• Mopar P/N 82206828 with P235/70R16 and P235/
65R17 tires.
• Mopar P/N 82207074 with P215/75R16 tires.
NOTE: In order to avoid damage to tires, chains, and
your vehicle do not drive for a prolonged period of time
on dry pavement. Observe the tire chain manufacturer's
instructions on method of installation, operating speed,
and conditions for usage.
Always use the lower suggested operating speed if both
the chain manufacturer and vehicle manufacturer sug-
gest a maximum speed. This notice applies to all chain
traction devices, including link and cable (radial) chains.