Panic Alarm; To Use The Panic Alarm - Jeep 2005 Liberty Owner's Manual

WARNING!
To avoid injury stand back when opening. Glass will
automatically rise.
NOTE: The transmitter can be programmed to unlatch
the flip-up window immediately upon activation of the
"Rear Release" button (without pressing and holding)
(within 23–50 feet (7–15 meters) of the vehicle) by per-
forming the following procedure:
1. Press and hold the "Unlock" button on the transmitter.
2. Continue to hold the "Unlock" button, wait at least 4
but no longer than 10 seconds, then press the "Rear
Release" button.
3. Release both buttons.
4. Repeating steps 1–3 will restore original transmitter
operation.
THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 27
NOTE: Unlatching the flip-up window will unlock the
swing gate. After closing the flip-up window, press the
"Lock" button on the transmitter to lock the swing gate.

Panic Alarm

The panic mode flashes the park lights, and sounds the
horn for about 3 minutes or until the alarm is turned off.

To Use the Panic Alarm

Press and hold the PANIC button for at least 1 second to
activate the panic alarm. Press and hold the PANIC
button a second time to deactivate the alarm. The alarm
will also shut itself off after starting the vehicle and
accelerating to 15 mph (24 km/h).
NOTE: The "Panic" and "Security" alarms are quite
different. Please take a moment to activate the "Panic"
and the "Security" modes to hear the differences in the
horn. In case one should go off in the future, you will
need to know which mode has been activated in order to
deactivate it.
2