Installation And Operating Conditions - Whirlpool ADN 140W Instruction Manual

CAUTION! If the installed interior lighting diode (LED) lamp for the cooling
–
device is not functioning, contact the maintenance and repair representative for
replacements. LAMPS CAN BE REPLACED ONLY BY THE MAINTENANCE
AND REPAIR REPRESENTATIVE.
If the appliance is out of order and it is not possible to repair it by means of
given recommendations, unplug it, open the doors and call the service
expert. Only a service representative can remedy all technical or
construction faults
If the appliance is unplugged (for cleaning, moving to another place, etc.), it
–
may be repeatedly switched on after 15 min.
Pull the plug out from the mains socket before each maintenance activity. Do
–
not pull on the cord, but hold the body of the plug instead.
The appliance should be used only for storing foodstuffs.
–
This appliance is not designed for the storage of explosive substances such as
–
aerosol cans with a flammable propellant.
It is prohibited to store petrol and other flammable liquids near the appliance.
–
The appliance can't be disposed of by burning.
–
Do not place any switched on electrical devices on top of the appliance because
–
this may cause ignition of plastic parts.
Do not place any dishes with liquids on top of the appliance and do not keep
–
flowers in vases or other liquid-filled vessels on the appliance. Do not lean on or
hang on the appliance doors and do not allow children to do this.
The appliance should be transported only in the vertical position. THE
MANUFACTURER WILL NOT BE RESPONSIBLE FOR ANY DAMAGE OF THE
APPLIANCE THAT RESULTS FROM NON-COMPLIANCE WITH THE INSTRUCTIONS
FOR TRANSPORTATION.

INSTALLATION AND OPERATING CONDITIONS

Position:
This appliance can be installed in a dry, well ventilated indoor where the ambient
•
temperature corresponds to the climate class indicated on the rating plate of the
appliance.
WARNING! The appliance should not be operated in an unheated room or
porch. Place the appliance away from heat sources such as kitchen
stove/oven, radiators, or direct sunlight.
The rear wall of the refrigerator, in particular, the condenser and other
elements of the cooling system must not contact other elements, which may
damage them, (e.g. central heating pipes and the water supply pipes).
4