Initial Operation; Application - Pettec Modular Remote Quick Start Manual

Initial operation

Remote
The display and background illumination of the remote control are auto-
matically turned on whenever one of the buttons is pressed. The background
illumination remains on for 20 seconds and then turns off if no other button
is pressed. If the remote control is not used for 5 minutes thereafter, the
display turns off and the remote control goes into energy-saving mode. The
unit will be active and ready to use when a button is pressed again.

Application

Important: This remote control works only with the PetTec Modular Vibra or
Modular Spray Trainer.
Selection of connected Trainer
1
The selection button allows the user to choose from two different Trainers
(sold separately). This allows you to use one remote control to control two
Trainers simultaneously.
Selection of training signal strength
2
Adjust the strength of the tone signal and the spray or vibration
strength, depending on the connected Trainer (Modular Spray or
Modular Vibra Trainer).
Tone signal button
3
The tone signal button triggers an audible tone on the training collar. The
strengths of the tone signal can be set by the adjustment buttons (
The volume is increased or decreased incrementally by pressing the up
and down buttons.
Vibration and spray signals
4
Pressing the training signal button will trigger the corresponding
signal (spray or vibration) from the training collar.* The intensity of
*Training collar (Modular Spray or Modular Vibra) is available separately.
6
).
