Charging The Battery - Pettec Modular Remote Quick Start Manual

Charging the battery

Charge the battery completely before the first use (this may take up to
•
2 hours).
Do not charge the battery near flammable substances.
•
The battery must be completely recharged if the Trainer has not been
•
used for more than three months.
The battery must be recharged if:
the battery indicator on the remote control shows only one bar instead
•
of three bars.
the indicator light on the remote control does not light up.
•
Important information
The remote control battery is only partially charged at the factory. The first
complete charge may take up to two hours.
Charging the remote control
Charge the remote control completely, using the included charging cable,
until the indicator bars on the unit are full. To do this, open the rubber
cover on the back of the remote control and insert the charging plug into the
opening provided. Then connect the USB connector to the adapter and plug
the charging device into a power outlet. A complete charging cycle takes
about two hours.
10