Pettec Modular Remote Quick Start Manual page 12

To test the connection, press the »Light« button on the remote control.
•
If the connection is successful, both LED's on the training collar will
now illuminate.
• Please start again with step 1 if the remote control and training collar
fail to connect.
Pairing and disconnecting the remote control to/from a training collar
Disconnecting the devices to use the anti-bark mode
1. Be sure that both devices are turned on.
Press and hold the »Up« and »Light« buttons on the Modular Remote
2.
simultaneously for several seconds. The indicator LED on the remote
control will flash red three times and the unit will beep.
3. The devices are now disconnected from each other, and the training
collar can now be used as an anti-bark device without using the remote
control.
Reconnecting the devices for use with remote training
1. Be sure that both devices are turned on.
Press and hold the »Up« and »Light« buttons on the Modular Remote
2.
simultaneously for several seconds. The indicator LED on the remote
control will flash red three times, signaling that it is ready to connect.
3. Now the remote control will connect to the training col-
lar within a few seconds. Upon successful connection, the
indicator LED on the Trainer will glow green.
4. Now you can use the devices for remote training again.
Note
To pair a training collar with a brand new remote control, you will need to
complete the procedure for establishing an initial connection.
12