Pairing The Remote Control And Trainer - Pettec Modular Remote Quick Start Manual

Pairing the remote control and Trainer

Important
• The Modular Remote can only be paired with the Modular Vibra or
Modular Spray Trainer collars. These items can be purchased
separately!
• Carefully read the instructions and safety notice for the training collars
before using.
• Only connect and disconnect the devices when your dog is not wearing
the training collar.
Important information
• Completely charge the remote control and training collar before
pairing the devices.
• The Modular Remote works with both training collars (Modular Spray
and Modular Vibra Trainer).
• Up to 2 training collars can be paired with a single remote control. This
means that you can control both a Modular Spray and a Modular Vibra
Trainer (both available separately) with the Modular Remote.
Initial pairing of the remote control with a training collar
(for remote training)
• Turn on the training collar and check the
battery level.
Then press and hold the »S« (Sensitivi-
•
ty) button on the training collar for several
seconds, until a »P« (Pairing) shows on the
LED display. Now the training collar will be in pairing mode for about
20 seconds.
Now take the Modular Remote and press the »Up« and »Light« buttons
•
simultaneously for several seconds. The indicator LED on the remote
control will flash red three times, signaling that it is ready to connec.
• Now the remote control will connect to the training collar within
several seconds. Upon successfully connecting, the indicator LED on
the Trainer will glow green.
https://pettec.de/shop/trainer/

Note: see photo
gallery p. 27
11