BWT AQA Monitor Installation And Operating Instructions Manual
Filter capacity control unit
Hide thumbs
Also See for AQA Monitor:
Subscribe to Our Youtube Channel
Related Manuals for BWT AQA Monitor
Summary of Contents for BWT AQA Monitor
- Page 1 AQA Monitor FILTER CAPACITY CONTROL UNIT Installation and operating instruction...
-
Page 2: Delivery Scope
Taste „PROG” Display Deckel des Batteriefachs DISPLAY RESET Anschluss Eingangsseite Anschluss Ausgangsseite PROG www.bwt.com Delivery scope 1 x Counting unit 1 x Bracket for wall installation 1 x Sensor unit - flow rate 2 x Flat seals 2 x AA batteries “DISPLAY/RESET” button “PROG” button... -
Page 3: Safety Regulations
Safety regulations Installation information » Read through the Operating Instructions carefully » The installed lengths of the AQA Monitor and the bending radius of the hoses are adhered to before the start of operation. Perform all steps exactly as indicated in the instructions. -
Page 4: Technical Data
Guarantee In the event of a fault during the guarantee Technical Data: period, please contact your contracting partner. Operator Duties » You have purchased a long-lasting and Connection thread (IN/OUT): 3/8” nut x 3/8” service-friendly product. However, every connection thread technical appliance requires regular service work to maintain correct Intake pressure (min/max):... -
Page 5: Installation
Installation Insert and change of battery DISPLAY RESET 1000 PROG www.bwt.com... - Page 6 Install counting unit Place counting unit on an easy accessable and well-visible position..
- Page 7 Install sensor unit - flow rate...
- Page 8 When installing, the unit the water supply must be closed. If the connections have been carried out professionally, check the system for leaks. If it is not tight, check the connections again.
- Page 9 Counting unit setting and function Filter capacity of the cartridge must be known and can be found in the installation and operation instruction. ad. 4: Set the desired value by pressing the “DISPLAY/RESET” button. ad. 5: Press the “PROG” button once to switch to the next digit. Repeat steps 4 and 5 until all digits have been set.
- Page 10 1oo0o ooo0o Prog 1oo0o 1 SEC. oooo0 oooo oooo0...
- Page 11 1oo0o...
- Page 12 Resetting the filter capacity (after water filter replacement) 4 SEC. Back to 2.a page 9...
- Page 13 Function counting unit 4 SEC. oooo 0 l Back to 2.a page 9...
- Page 15 812641 Bestell-Nummer: Order number: BWT UK Limited BWT House, The Gateway Centre, Coronation Road, High Wycombe, Buckinghamshire. HP12 3SU 04194838100 enquiries@bwt-uk.co.uk bwt.com bwt.com...
Need help?
Do you have a question about the AQA Monitor and is the answer not in the manual?
Questions and answers