A. Low-Beam Headlamp
B. High-Beam Headlamp
3. Pull the headlamp assembly out.
4. Unplug the electrical connector.
5. Turn the bulb counterclockwise and remove it from
the headlamp assembly.
6. Put the new bulb into the headlamp assembly and
turn it clockwise until it is tight.
7. Plug in the electrical connector.
8. Put the headlamp assembly back into the vehicle.
9. Install and turn the two pins to secure the headlamp
assembly.
Front Turn Signal, Sidemarker and
Daytime Running Lamps
A. Sidemarker Lamp
B. Retainer Clip
To replace a front turn signal, sidemarker or DRL bulb,
do the following:
1. Open the hood. See Hood Release on page 5-11
for more information.
2. Remove the headlamp assembly as described
previously. See Headlamps on page 5-50 for
more information.
C. Front Turn Signal Lamp
D. Daytime Running
Lamp (DRL)
5-51