Table of Contents
Advertisement
3. Under the Media Files category, choose "All Files (*)"
4. Choose the SDP file provided by Z3 Technology
- Note: If you do not have the SDP file, please to refer to your Z3 Server user account and download
the file.
5. If the original video is interlaced, the video can be deinterlaced as follows:
a. On the Video Menu, choose "Deinterlace" and choose an option other than "Disable"
7 DYNAMIC BIT-RATE & FRAME-RATE CHANGE
The dynamic bit-rate and frame-rate control will take effect, if you change *only* the following parameters:
Video Bit Rate
Frame Decimation
After the Video Bit Rate and Frame Decimation rate have been configured to your preferred settings, hit the
"Start Encoder" or "Restart Encoder" button.
The web page will respond with:
Status: Changed rate
The video stream will continue uninterrupted with the new parameter.
8 UPDATING FIRMWARE
8.1
WEB PAGE
-
Locate the UPD-z3-mve02-v1.04.00.img file on your Z3 Server user account
-
Save the file on your PC where it can easily be found
-
Follow steps 1 through 7 in section 4 WEB SERVER
On the web menu, next to "Firmware Version 1.0.4", hit the Update button
-
-
Hit Browse to find the saved .img file on your PC
-
Hit Upload & Update
-
Power off unit
-
Power cycle system for clean boot and system should be updated.
Z3 Technology, LLC ♦ 4701 Innovation Drive CB103 ♦ Lincoln, NE 68521 USA ♦ +1.402.323.0702
CONFIDENTIAL
MVE-02-V1.04.00 RELEASE
7
Advertisement
Table of Contents
