System Connections; Pc Setup; Web Server; Local Ip Settings - Encoder - Z3 Technology Z3-DM368-APP Manual

3 SYSTEM CONNECTIONS

The System can be controlled via the Web Server on the Z3-DM368-APP + Z3-DM368-MOD. It can also be
controlled via the serial port.

4 PC SETUP

Initially, the simplest way to setup the networked PC to communicate with the Z3-DM368-APP + Z3-DM368-
MOD is to put the PC on the same subnet as the Z3-DM368-APP + Z3-DM368-MOD.
Please see the Z3-DM368-APP + Z3-DM368-MOD default settings below:
IP Address: 192.168.0.65
Netmask Address: 255.255.0.0
Gateway IP Address: 192.168.0.1
Server IP Address: 192.168.0.6

5 WEB SERVER

Note: If you use unicast on the encoder, you must also use unicast on the VLC receiver. If you use
multicast on the encoder, you must also use multicast on the VLC receiver.
1. Power on the Z3-DM368-APP + Z3-DM368-MOD
2. Wait one minute or until LED #1 on the unit lights up
3. Connect the Ethernet cable from the Z3-DM368-APP + Z3-DM368-MOD unit directly to the PC
4. Disable any wireless connections
5. For a client PC to access the Z3-DM368-APP + Z3-DM368-MOD factory default settings, set the
IP address of the PC to 192.168.XX.XX
6. Open Firefox or Internet Explorer 8 (or above) as your web browser.
7. Type the IP address of the Z3-DM368-APP + Z3-DM368-MOD in your web browser
(http://192.168.XX.XX) and the Z3-DM368-APP + Z3-DM368-MOD Encoder web configuration
menu will appear
8. Configure the Z3-DM368-APP + Z3-DM368-MOD with your desired settings
9. Press "Start Encoder" on the Encoder Control menu
5.1

LOCAL IP SETTINGS - ENCODER

Z3 Technology, LLC ♦ 4701 Innovation Drive CB103 ♦ Lincoln, NE 68521 USA ♦ +1.402.323.0702
CONFIDENTIAL MVE-02-V1.04.00 RELEASE
5