Table of Contents
Advertisement
1. In the Local IP Settings Section type in your desired Local IP settings
2. Hit "Save User" to save your desired settings
3. Power cycle the Z3-DM368-APP + Z3-DM368-MOD
4. The new IP settings will now take effect
6 STREAMING OPERATION
After connecting your video/audio source and configuring the Z3-DM368-APP + Z3-DM368-MOD Encoder,
hit "Start Encoder" so the status below says "Status: Running." If you are using the serial command instead,
type "S" to start streaming.
The way to set up VLC as your stream receiver on your PC differs depending on the format of your output
stream.
If your output format is transport stream, please follow the steps below:
6.1
TRANSPORT STREAM
1. Open VLC Media Player
2. On the Media menu choose "Open Network Stream" (Cntrl + N)
3. If using VLC version 1.0.X:
a. On the Protocol menu choose "UDP"
b. Type in the static IP address of your personal PC
c. Change the Port Address to "8888"
4. If using VLC version 1.1.X:
a. Enter the network URL as follows: udp://@xxx.xxx.xxx.xxx:8888 (where xxx.xxx.xxx.xxx is the
IP Address of your personal PC)
5. Press play
6. If the original video is interlaced, the video can be deinterlaced as follows:
a. On the Video Menu, choose "Deinterlace" and choose an option other than "Disable"
If your output format is real-time transport protocol, please follow the steps below:
6.2
REAL-TIME TRANSPORT PROTOCOL
1. Open VLC Media Player
2. On the Media menu choose "Open File" (Cntrl + O)
Z3 Technology, LLC ♦ 4701 Innovation Drive CB103 ♦ Lincoln, NE 68521 USA ♦ +1.402.323.0702
CONFIDENTIAL
MVE-02-V1.04.00 RELEASE
6
Advertisement
Table of Contents
