Table of Contents
Advertisement
Taillamps
1. Open the endgate.
2. Remove the two screws
from the lamp assembly.
3. Pull the assembly away from the vehicle.
4. Turn the socket counterclockwise to remove
it.
Push
the tab in while you turn the socket
counterclockwise.
5 . Holding the base
of
the bulb, pull the bulb straight
out
of the socket.
6. Push the new bulb straight into the socket until
it clicks.
7.
Put the
socket
into the lamp assembly and turn the
socket clockwise until it locks into place.
8. Install the lamp assembly and screws.
9. Close the endgate.
Underhood Lamp
1 . Disconnect the electrical connector from the
underhood lamp assembly.
2. Remove the screws.
3 .
Disconnect the ground wire.
4. Remove the lamp assembly from the hood.
5 . Install the new bulb.
6. Replace the assembly. Install and tighten the screws.
7. Connect the ground wire.
8. Connect the electrical connector
to the
lamp assembly.
6-37
Advertisement
Table of Contents
