How It Works - Xpelair XPDH16T Instruction Manual

Quick start/ First time operation
1. Before switching on for first time please ensure unit has settled for 12 hours.
2. Please remove 'carbon filter' from its bag and locate between the anti- dust filter and air inlet on the
body of the product (make sure carbon filter is lined up properly with guide locators on the air inlet).
3. Ensure pre filter and carbon filter is fitted securely to the product before switching on.
4. Plug product in.
5. Press on/off button.
6. Select the humidity control button and keep pressing until 'cont' lights up- this will set product to run
continuously- leave to 3 minutes then adjust humidity control to your desired setting. The lower the
setting e.g 40% the product will try and target 40% relative humidity (ambient humidity) which is
for drier conditions. Nearer 70% setting, the product will try and target 70% relative humidity
e.g. more humid/ moist conditions.
Unless this setting is changed, the product will now start controlling the ambient humidity in the room.

How It Works

Motor
Compressor
This product is a dehumidifier. It controls relative humidity by passing the air through the unit, forcing the
excess moisture to condensate over the cooling elements.
Contact with this cold surface causes the moisture in the air to condense. This condensed water then drains safely
into the water tank. The dried air then passes through the condenser where it is slightly warmed and re-enters
the room at a slightly elevated temperature. N.B. As with all compressor type dehumidifiers their effectiveness is
reduced the colder the ambient temperature is.
8
Air Outlet
Fan
Air Inlet
Condenser
Evaporator
Water tank