Operation - Xpelair XPDH16T Instruction Manual

Operation

1. Plug the unit into a correct mains socket. (Please refer to the rating label at the rear of the unit for
correct voltage/frequency.)
2. Press ON/OFF button to turn on the unit. The compressor will start to work.
3. Press humidity setting button to set the working mode you need require: continuous working,
humidity 40%, 50%, 60% or 70%. If you prefer dryer conditions (reduced humidity) set towards 40%.
For more humid conditions set towards 70%. 'CONT' means the unit will be set to Continuous and will
continue to run regardless of humidity level.
1. Press speed/ventilation button to set the ventilation speed, high or low. The relative indicator light will
be on to indicate the setting currently selected.
2. Press the TIMER button to set the operating time you require (1~24 hours). The display window will
show the time in hours you set as you press the TIMER button, the display window will return to show
room humidity after around 8 seconds. When the set time has been reached, the compressor will stop
working automatically.
3. By pressing the "TEMP" button, the display window will show the room temperature, after releasing
the button the display window will return to show the room humidity after around 8 seconds.
4. DRYER function uses turbo ventilation to dry the moisture in the air continuously, it can help to dry
laundry by removing more moisture from the air.
5. If you don't want to dry the air and just want to circulate the air or to help remove an odour from a room,
please press AIR CLEAN button which will disengage the dehumidifier function and operate the
product as an air circulating filter only. (Selected models only)
6. To turn off the unit, press ON/OFF button again.
7. Pre-setting function: By pressing the TIMER button without turning on the other functions (including
ON/OFF button), you can PRE-SET the time for the product to switch on later. For example, if you
press the timer to '2', the unit will switch on automatically after 2 hours.
11