General Operating Instructions - Power Cooker PC-WAL2 Owner's Manual

Digital pressure cooker 6 and 8 quart
Hide thumbs Also See for PC-WAL2:
Table of Contents

Advertisement

GENERAL OPERATING INSTRUCTIONS

LED DISPLAY
A
B
CONTROL PANEL
C
BASE
D
INNER POT NOTE: MAX FILL LINE
Place INNER POT into the unit. Never fill the
INNER POT above the MAX line.
E
LID
LID HANDLE
F
RUBBER GASKET - UNDER LID
G
For proper cleaning the RUBBER GASKET
should be removed. Using the PULL TAB located
beneath the LID, remove the POT LID LINER
that holds the GASKET. A er cleaning, re-attach
GASKET to LID LINER and snap back in place.
H
LOCK SYMBOLS
PRESSURE RELEASE VALVE
I
FLOATING VALVE
J
K
RAPID RELEASE BUTTON
L
AC CORD
M
STEAMER TRAY
To steam vegetables and other foods, add liquid
to the INNER POT and place Steamer Tray in the
pot so that it rests evenly on the groove.
Clean a er each use.
N
CONDENSATION COLLECTOR
Align the collector with the two grooves on the
back of the cooker to capture moisture that may
drip. Empty and clean a er each use.
O
MEASURING CUP
P
LADLE
Q
RED PRESSURE INDICATOR
S
MAGNETIC SENSOR
RECOMMENDED STEPS BEFORE FIRST USE
Before using the Power Cooker for the first time, wash
the INNER POT (D), the LID (E) and the RUBBER
GASKET (G) with warm soapy water. Rinse with clean
water and dry thoroughly.
Make sure the RUBBER GASKET (G) is seated properly
inside the LID.
To ensure correct fitting of the RUBBER GASKET (G),
fill the INNER POT (D) with water about 1/5 full.
IMPORTANT LID SAFETY PRECAUTIONS
The unit has a MAGNETIC SAFETY SENSOR (S) to assure
the lid is properly closed and the unit can pressurize. If the lid is
not on correctly a beeping noise will occur and the word "LID"
will appear on the display indicating the lid is not fully closed
and the unit cannot pressurize.
Place Cooker LID (E) on Cooker with LID Handle (F) and
PRESSURE RELEASE VALVE (I) pointed to the "1:00
o'clock" position (fig. A). Rotate LID counterclockwise until
you feel a click and the LOCK SYMBOLS (H) on the LID are
centered with the LED Display (A).
Place the LID (E) on the cooker, then slide the RAPID
RELEASE BUTTON (K) to the CLOSE position and run on
COOK mode for 15 minutes. Always make sure nothing is
blocking the PRESSURE RELEASE VALVE or LID from
achieving a tight seal when closed.
Wait 15 minutes, then release pressure by sliding the RAPID
RELEASE BUTTON (K) to the RELEASE position.
The FLOATING VALVE (J) and the RED PRESSURE
INDICATOR (Q) will drop. Let the appliance cool to room
temperature. Pour out the water. Rinse and towel dry the
INNER POT. The Power Cooker is now ready for use.
CAUTION
The RED PRESSURE INDICATOR (Q) on lid indicates that the
unit is pressurized. Do NOT touch or press the indicator, doing so
will release hot steam which reduces the unit's pressure and can
cause injury. Always use the manual pressure release valve to
release pressure.
H
6-QUART POWER COOKER™ MODEL:PC-WAL2 | 8-QUART POWER COOKER™ MODEL:PC-WAL3 |
S
J
I
K
Q
F
9

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the PC-WAL2 and is the answer not in the manual?

Questions and answers

This manual is also suitable for:

Pc-wal3

Table of Contents

Save PDF