Do you have a question about the PC-WAL4 and is the answer not in the manual?
Questions and answers
Robyn Detert
January 25, 2025
I put water in for first use. Plugged in & it lit up. I do not have manual. Need to run 15 mins but no start button. How do you start it?
1 comments:
Mr. Anderson
February 10, 2025
Before using the Power Cooker PC-WAL4 for the first time, follow these steps:
1. Wash Components – Clean the INNER POT, LID, and RUBBER GASKET with warm soapy water, rinse, and dry thoroughly. 2. Check the RUBBER GASKET – Ensure the RUBBER GASKET is properly seated inside the LID. 3. Insert INNER POT – Place the INNER POT into the unit, ensuring it does not exceed the MAX fill line. 4. Test Fit – Fill the INNER POT about 1/5 full with water to check the RUBBER GASKET’s fit. 5. Close the LID – Properly secure the LID. The MAGNETIC SAFETY SENSOR will beep and display “LID” if it is not fully closed. 6. Power On – Plug in the unit and select a desired cooking mode from the Digital Display. 7. Adjust Settings – Set cooking time and pressure level as needed. 8. Start Cooking – Begin the cooking cycle. The unit will automatically switch to KEEP WARM mode after cooking.
Page 1
10-Quart Digital Pressure Cooker OWNER’S MANUAL MODEL: PC-WAL4 Important: When using electrical appliances, basic safety precautions should always be followed. Do not use this Power Cooker until you have read this manual thoroughly. Warranty information inside. SAVE THESE INSTRUCTIONS. FOR HOUSEHOLD USE ONLY.
LIMITED WARRANTY SPECIAL FEATURES BUILT-IN SAFETY FEATURES IMPORTANT SAFEGUARDS PARTS AND ACCESSORIES GENERAL OPERATING INSTRUCTIONS DIGITAL CONTROL PANEL OVERVIEW PRESSURE COOKING GUIDE CARE AND CLEANING FLOAT VALVE ASSEMBLY FREQUENTLY ASKED QUESTIONS TROUBLESHOOTING DISPLAY ERROR INDICATOR 10-QUART POWER COOKER™ MODEL:PC-WAL4 |...
The manufacturer warrants that your Power Cooker™ is free of defects in materials and workmanship WARRANTY and will, at its option, repair or replace any defective Power Cooker™ that is returned to it. All parts and components of the Power Cooker™ are warranted for 60 days from the original date of purchase.
SPECIAL FEATURES The Digital Display on your Power Cooker offers a wide range of choices including Browning, Low Temp Cooking, Stewing DIGITAL DISPLAY and Steaming. Cooking Time and Pressure Levels may be adjusted to suit any recipe or personal preference. At the completion of the cooking cycle, the unit will automatically shift to the KEEP WARM mode.
“LID” will appear on the display indicating the lid is MAGNETIC SENSOR not fully closed and the unit cannot pressurize. See the General Operating Instructions section to familiarize how to properly place the lid on the unit FOR LID and lock it securely. | 10-QUART POWER COOKER™ MODEL:PC-WAL4...
The Power Cooker generates extreme heat and steam in its THIS APPLIANCE SHOULD NEVER BE OPERATED BY operation. All necessary precautions must be taken to avoid fire, CHILDREN AND SPECIAL CARE SHOULD BE TAKEN WHEN burns and other personal injury during its operation.
GENERAL OPERATING INSTRUCTIONS LED DISPLAY RECOMMENDED STEPS BEFORE FIRST USE Before using the Power Cooker for the first time, wash CONTROL PANEL the INNER POT (D), the LID (E) and the RUBBER GASKET (G) with warm soapy water. Rinse with clean BASE water and dry thoroughly.
DIGITAL CONTROL PANEL OVERVIEW 0000 The Power Cooker has several basic cooking modes that may COOK TIME BUTTON (9) - You can change the default time be used alone or in combination to produce an infinite variety of when pressing the cook time button.
INNER POT (page 8). When using foods that expand during cooking towels, paper towels, curtains, paper plates, etc. When in operation the Power Cooker requires sufficient air space on all sides including top such as rice or dried beans, follow the recipe for “pressure cooking”...
Page 12
Unless you are familiar with the pressure cooking process, follow recipes carefully for liquid addition suggestions. Never fill INNER POT above MAX line. Always use PRESSURE RELEASE VALVE to lower pressure quickly. DO NOT open the Power Cooker until the unit has cooled and all internal pressure VEGETABLES LIQ/CUPS APPROX.
Note: The RUBBER GASKET must be replaced every year, or sooner if necessary. The RUBBER GASKET may also need replacing if Power Cooker is not used for a long period of time, as it can harden from disuse, making it unable to form an airtight seal.
LID to the stainless steel side. FREQUENTLY ASKED QUESTIONS 1. DOES THE POWER COOKER HAVE LEAD IN IT? 2. WHAT TYPE OF STEEL IS THE UNIT MADE OF? Stainless Steel 3. IS IT NORMAL TO HAVE STEAM COME OUT OF THE SIDES? If there is steam coming out of the sides and the button on top of the LID is in the closed position, then the LID has not seated.
BEEPING SOUND & DISPLAY Lid may be in the incorrect position Make sure lid is positioned correctly READS "LID DISPLAY ERROR INDICATOR INDICATOR CODE PROBLEMS/CAUSES Circuit open of sensor Short circuit of sensor Overheating Pressure switch malfunction 10-QUART POWER COOKER™ MODEL:PC-WAL4 |...
Need help?
Do you have a question about the PC-WAL4 and is the answer not in the manual?
Questions and answers
I put water in for first use. Plugged in & it lit up. I do not have manual. Need to run 15 mins but no start button. How do you start it?
Before using the Power Cooker PC-WAL4 for the first time, follow these steps:
1. Wash Components – Clean the INNER POT, LID, and RUBBER GASKET with warm soapy water, rinse, and dry thoroughly.
2. Check the RUBBER GASKET – Ensure the RUBBER GASKET is properly seated inside the LID.
3. Insert INNER POT – Place the INNER POT into the unit, ensuring it does not exceed the MAX fill line.
4. Test Fit – Fill the INNER POT about 1/5 full with water to check the RUBBER GASKET’s fit.
5. Close the LID – Properly secure the LID. The MAGNETIC SAFETY SENSOR will beep and display “LID” if it is not fully closed.
6. Power On – Plug in the unit and select a desired cooking mode from the Digital Display.
7. Adjust Settings – Set cooking time and pressure level as needed.
8. Start Cooking – Begin the cooking cycle. The unit will automatically switch to KEEP WARM mode after cooking.
This answer is automatically generated