Alpine CDE-205DAB Owner's Manual page 38

Dab/cd/usb receiver with advanced bluetooth
Table of Contents

Advertisement

Fuse Holder (10A)
Fuse replacement:
When replacing the fuse, be sure to use one
matching the amperage rating stated on the
original fuse. If the fuse blows, check the
power connection and replace the fuse. If the
fuse blows again after replacement, there
may be an internal malfunction. In such a
case, consult your nearest Alpine dealer.
Fuse (10 A)
Power Supply Connector
MIC Input Connector (CDE-205DAB/ UTE-
204DAB only)
To Microphone.
Steering Remote Control Interface
Connector
To steering remote control interface box. For
details, contact your Alpine dealer.
Front Output RCA Connectors
RED is right and WHITE is left.
Rear Output RCA Connectors (CDE-
205DAB/ UTE-204DAB only)
RED is right and WHITE is left.
Subwoofer Output RCA Connectors
Antenna Receptacle
DAB Antenna Connector
To DAB Antenna (sold separately).
Remote Turn-On Lead (Blue/White)
Connect this lead to the remote turn-on lead
of your amplifier or signal processor.
Switched Power Lead (Ignition) (Red)
Connect this lead to an open terminal on the
vehicle's fuse box or another unused power
source which provides (+) 12V only when the
ignition is turned on or in the accessory
position.
Ground Lead (Black)
Connect this lead to a good chassis ground
on the vehicle. Make sure the connection is
made to bare metal and is securely fastened
using the sheet metal screw provided.
38
-EN
Power Antenna Lead (Blue)
Connect this lead to the +B terminal of your
power antenna, if applicable.
• This lead should be used only for controlling
the vehicle's power antenna. Do not use this
lead to turn on an amplifier or a signal
processor, etc.
Dimmer Lead (Orange)
This lead may be connected to the vehicle's
instrument cluster illumination lead.
• This will enable the vehicle's dimmer control
to dim the backlighting of the unit.
Battery Lead (Yellow)
Connect this lead to the positive (+) post of
the vehicle's battery.
ISO Power Supply Connector
ISO Connector (Speaker Output)
Left Rear (+) Speaker Output Lead (Green)
Left Rear (−) Speaker Output Lead (Green/
Black)
Left Front (+) Speaker Output Lead (White)
Left Front (−) Speaker Output Lead (White/
Black)
Right Front (−) Speaker Output Lead (Grey/
Black)
Right Front (+) Speaker Output Lead (Grey)
Right Rear (−) Speaker Output Lead
(Violet/Black)
Right Rear (+) Speaker Output Lead
(Violet)
RCA Extension Cable (not supplied)

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ute-204dabUte-202dab

Table of Contents