Setting The Temperature - Dometic CFX100W Professional Operating Manual

Operation
I
NOTE
Place the cooler as shown (fig. 1, page 3). If you operate the box in a
different orientation it can be damaged.
➤ Connect the cooler, see chapter "Connecting the cooler" on page 16.
A
NOTICE! Danger from excessively low temperature!
Ensure that only those objects are placed in the cooler that are intended
to be cooled at the selected temperature.
➤ Press the "ON/OFF" button (fig. 3 1, page 4) for between one and two
seconds.
✔ The LED "P" lights up (fig. 3 2, page 4).
✔ The display (fig. 3 5, page 4) switches on and shows the current temperature.
✔ The cooler starts cooling the interior.
I
NOTE
When operating with the battery, the display switches off automatically
if the battery voltage is low. The LED "P" flashes orange.
Latching the cooler lid
➤ Close the lid.
➤ Press the latches (fig. 2 1, page 3) down, until they latch in place audibly.
I
NOTE – "Lid open" alarm
If the lid is left open for three minutes or more and the device is switched
on, the interior light will flash until the lid is closed.
7.6

Setting the temperature

➤ Press the "SET" button (fig. 3 4, page 4) once.
➤ Use the "UP +" (fig. 3 7, page 4) and "DOWN –" (fig. 3 6, page 4) buttons to
select the cooling temperature.
✔ The cooling temperature appears in the display for a few seconds. The display
flashes several times and then the current temperature is displayed again.
20
CFX100W
EN