Table of Contents
Advertisement
Dunlop valve
Only applies to pedelecs with this equipment
The tyre pressure cannot be measured on the
simple Dunlop valve. The tyre pressure is
therefore measured in the filling hose when
pumping slowly with the bicycle pump.
It is recommendable to use a bicycle pump with a
pressure gauge.
1 Unscrew and remove the valve cap.
2 Undo the rim nuts.
3 Connect the bicycle pump.
4 Pump up the tyre slowly and pay attention to
the tyre pressure in the process.
5 Correct the tyre pressure to meet the specified
value in the Pedelec pass.
6 If the tyre pressure is too high, unfasten the
union nut, let air out and re-tighten the union
nut.
7 Remove the bicycle pump.
8 Screw the valve cap tight.
9 Screw the rim nut gently against the rim with
the tips of your fingers.
Correct tyre pressure if necessary (see
Section
6.6.8).
Schrader valve
Only applies to pedelecs with this equipment
It is recommended to use the air pump at a filling
station. Older and easy bicycle pumps are
unsuitable for filling tyres via a Schrader valve.
1 Unscrew and remove the valve cap.
1 Undo the rim nuts.
2 Attach the bicycle pump.
3 Pump up the tyre slowly and pay attention to
the tyre pressure in the process.
The tyre pressure has been adjusted as per the
specifications.
4 Remove the bicycle pump.
5 Screw the valve cap tight.
MY22K03 - 32_1.0_13.09.2021
6 Screw the rim nut gently against the rim with
the tips of your fingers.
Correct tyre pressure if necessary (see
Section
6.6.8).
Presta valve
Only applies to pedelecs with this equipment
It is recommendable to use a bicycle pump with a
pressure gauge. The operating instructions for
the bicycle pump must be adhered to.
1 Unscrew and remove the valve cap.
2 Open the knurled nut around four turns.
3 Carefully apply the bicycle pump so that the
valve insert is not bent.
4 Pump up the tyre slowly and pay attention to
the tyre pressure in the process.
5 Correct the tyre pressure as per the
specifications on the tyre.
6 Remove the bicycle pump.
7 Tighten the knurled nut with your fingers.
8 Screw the valve cap tight.
9 Screw the knurled nut gently against the rim
with the tips of your fingers.
Correct tyre pressure if necessary (see
Section
6.6.8).
Cleaning and servicing
148
Advertisement
Chapters
Table of Contents
