Advertisement
Available languages
Available languages
Starter
Content:
Hose pipe
Screen
coupling
filter
13 mm (½")
These parts are already pre-assembled!
2 x
Barb connector T
Technical requirements:
Water supply with a minium pressure of 1.5 bar., delivery pipe with fast connector. Drawing water from
other sources (e.g. rainwater) requires installation of an additional filter. In this case, contact your
professional supplier.
Installation:
Lay out the dripperline as required, e.g.
along a hedgerow. The dripperline can
also be installed sub-surface (close to
the roots).
Stabilizers help to keep the dripperline in
the required position.
Scan the QR-code with your smartphone to
watch the installation guide video.
Irrigation-Kit
Pressure reducer
Flat gasket
4 x
Barb connector straight
A double row installation can be done using
the Tconnector.
When cutting the dripperline to its required
length, keep a minimum distance of at least
5 cm to the next emitter.
Screw the pressure reducer onto the
preassembled start connector. In order
to start irrigating, simply connect your
system to the garden hosepipe. Our
connector is suitable for all current
13 mm (1/2") pipe and irrigation systems.
Making the system winter-proof:
Protecting your irrigation system from frost damage requires careful
preparation. Disassemble the pressure reducer and store it in a dry location
during winter. Open the line ends and remove all residual water from the
dripperlines.
Manual
Start connector
Start connector pre-assembled on dripperline!
3 x
Line end
50 m dripperline
(emitter spacing 30 cm)
20 x
Stabilizer
Close the dripperline with a line
end fitting as shown.
To clean the screen filter, unscrew
the pipe coupling connector.
When reassembling ensure that
the screen filter sits in the exact
position.
Advertisement
