Headlamp Aiming - Chevrolet 2005 Cobalt Owner's Manual

Notice: If the jumper cables are connected or
removed in the wrong order, electrical shorting may
occur and damage the vehicle. The repairs would
not be covered by your warranty. Always connect
and remove the jumper cables in the correct
order, making sure that the cables do not touch
each other or other metal.
Jumper Cable Removal
A. Heavy, Unpainted Metal Engine Part or Remote
Negative ( ) Terminal (GND)
B. Good Battery or Remote Positive (+) and Remote
Negative ( ) Terminals
C. Dead Battery or Remote Positive (+) Terminal
5-44
To disconnect the jumper cables from both vehicles, do
the following:
1. Disconnect the black negative ( ) cable from the
vehicle that had the dead battery.
2. Disconnect the black negative ( ) cable from the
vehicle with the good battery.
3. Disconnect the red positive (+) cable from the
vehicle with the good battery.
4. Disconnect the red positive (+) cable from the
other vehicle.
5. Return the positive (+) terminal cover to its
original position.

Headlamp Aiming

The vehicle has a visual optical headlamp aiming
system. The aim has been preset at the factory and
should need no further adjustment
However, If the vehicle is damaged in an accident, the
headlamp aim may be affected and adjustment may
be necessary.
If oncoming vehicles flash their high beams at you, this
may also mean the vertical aim needs to be adjusted.