Step 6 - Canopy Operations - GAGGLE JAMBOREE 6 Assembly Instructions Manual

To attach Rear Canopy:
1.
Position Rear Canopy (F) with rounded front section on
top and place canopy in rear seat area and over top
of front seats.
2.
Secure Main Canopy Tube (V) by pushing
end of Main Canopy Tube into Canopy Retainer (Z) slot
located on outside of Handle (X) near the Armrest (W)
(Fig. 1).
3.
Secure short Rear Canopy Tube (Y) by pushing
end of Canopy Tube into Canopy Retainer (Z) slot
located on outside of the handle near the top of the
back seat (Fig. 2).
Repeat steps 2 and 3 to secure canopy tubes on other
side of stroller.
4.
Secure back of Rear Canopy (F).
- Fold back panel of canopy forward
rear canopy tube rearward and attach canopy
fabric over handle support tube with fabric
hook and loop fasteners
- Slide back panel of canopy (T) down between
handle support tube (U) and stroller handle
(Fig. 4).
- Secure canopy sides around stroller handle
support tube by securing hook & loop fasteners
on each side
- Repeat on other side of canopy.
Note: To remove Rear Canopy, follow steps above in
reverse order.
STEP 6 - Canopies
2
(Fig. 3).
4 (Fig. 4).
1
, pull
3
8
V
W
X
Y
1
2
2
1
T
Style May Vary
4
4
Fig. 1
Z
Fig. 2
Z
Fig. 3
2
2
U
Fig. 4
3