Toshiba RAV-RM301KRTP Series Service Manual page 77

10.8.5 Onboard Switch Setting Procedure
1. Remove the front panel.
• Before removing the front panel, direct th horizontal louver to the direction shown in the figure below.
• Remove the screws securing the front panel, and detach it from the indoor unit.
2. Remove the earth wire, TC sensor, TCJ sensor motor lead (louver motor, fan motor).
3. Remove the screws and detach the electrical control box.
4. Remove the electrical control box cover and set bit1 of SW01 on the board to ON. (Do not touch SW02
as it is used for other setting.)
5. Assemble the removed parts by reversing steps 1 to 3.
Insert the sensors and motor lead (louver motor, fan motor) into the original positions.
CAUTION
Connect the sensor and the motor lead certainly back to
the previous position. If they are not properly connected,
the system will not operate or other errors may occur.
P01
MCC-1696
CN61
CN50
CN32
- 77 -
FILE NO. SVM-18059
1 : OFF 1 : ON
2 : OFF 2 : OFF
ON ON
1 2 1 2
Factory
After setting
setting change