Chevrolet 2003 Tahoe Owner's Manual page 19

2. Make sure the head restraints have been lowered
completely.
3. With the seat folded, unlatch the seat from the floor
by pulling up on the lever located under the
carrying handle at the rear of the seat labeled 2.
4. Lift the rear of the seat up, off the floor. You will not
be able to unlatch the seat from the floor unless the
seatback is folded down.
5. Tilt the seat fully forward and secure it
in place
using the support rod located on the underside
of the seat on the passenger's side. Make sure the
rod pin is fully engaged in the lock.
rod is holding it firmly in place. Use the seat in this
position only when necessary for additional
cargo space.
6. Push and pull on the seat. Make sure the support
To return the seat to the seating position do the
following:
1. Push forward on the seat and release the support
2. Secure the support rod in its stored position on the
3. Lower the seat to the floor and let the seat drop
lock rod.
underside of the seat.
into place.
4. Lift up on the carrying handle to make sure the seat
is locked in place.
5. Return the seatback to the upright position by
pulling up on the release lever labeled 1 before
the back can be folded upright.
6. Pull the seatback forward to make sure it is locked
in place.
Removing the 50/50 Split Bench Seat
To remove the 50/50 split bench seat, do the following:
1. Open the rear doors and enter the rear of the
vehicle.
2. Fold the seatback
forward onto the seai
cushion by using
the lever labeled 1.
The seat cannot
be removed unless the
seatback is folded.
1-12