Parking Brake - Chevrolet 2003 Tahoe Owner's Manual

Table of Contents

Advertisement

Shifting Out
of
NEUTRAL
To shift out of NEUTRAL:
1. Set the parking brake and apply the regular brake
2. Shift the transmission to NEUTRAL (N) and turn the
3. Press the button for the desired transfer case shift
4. After the transfer case has shifted out of NEUTRAL
pedal.
ignition to RUN with the engine off.
position (All-Wheel Drive or 4LO).
the red light will go out.
5. YOU may start the engine and shift the transmission
to the desired position.
Parking Brake
To set the parking brake, hold the regular brake pedal
down with your right foot. Push down the parking
brake pedal with your left foot.
A chime will activate and the warning light will flash
when the parking brake is applied and the vehicle
is moving at least 3 mph (5 km/h) for at least
three seconds.
To release the parking brake, hold the regular brake
pedal down. Pull the bottom edge of the lever, located
above the parking brake pedal, with the parking
brake symbol, to release the parking brake.
If the ignition is on when the parking brake is released,
the brake system warning light will go off.
Notice: Driving with the parking brake on can
cause your rear brakes to overheat. You may have
to replace them, and you could also damage
other parts of your vehicle.
If you are towing a trailer and are parking on any hill,
see Towing a Trailer on page 4-59.
2-35

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

2003 suburban

Table of Contents