Chevrolet 2003 Corvette Owner's Manual page 179

4 REV (Reverse): Press this pushbutton to reverse the
tape rapidly. Press it again to return to playing speed.
The radio will play while the tape reverses.
00
5 (Dolby): Press this pushbutton to reduce
background noise. The double-D symbol will appear on
the display.
Dolby Noise Reduction is manufactured under a license
from Dolby Laboratories Licensing Corporation. Dolby
and the double-D symbol are trademarks of Dolby
Laboratories Licensing Corporation.
FWD 6 (Forward): Press this pushbutton to advance
quickly to another part of the tape. Press it again
to return to playing speed. The radio will play while the
tape advances.
4
SEEK
D
: Your tape must have at least three
seconds of silence between each selection for seek to
work. Press the right or the left arrow to go to the next or
to the previous selection on the tape.
AM FM: Press this button to listen to the radio when a
tape is playing.
TAPE AUX (Auxiliary): Press this button to play a
cassette tape when listening to the radio. The tape
symbol with an arrow will appear on the display while
the tape is active. If your system is equipped with
a remote playback device, pressing this button a second
time will allow the remote device to play.
EJECT: Press this button to remove the tape. The radio
will play. EJECT may be used with the ignition or radio
off. Cassettes may be loaded with the radio off if this
button is pressed first. If you leave a cassette tape in the
player while listening to the radio, it may become warm.
Cassette Tape Messages
CLN (Clean): If this message appears on the display,
the cassette tape player needs to be cleaned. It will
still play tapes, but you should clean it as soon as
possible to prevent damage to the tapes and player.
See Care of Your Cassette Tape Player on page 3-77.
CD Adapter Kits
It is possible to use a portable CD player adapter kit
with your cassette tape player after activating the bypass
feature on your tape player.
To activate the bypass feature, use the following steps:
1. Turn the ignition on.
2. Turn the radio off.
3. Press and hold the TAPE AUX button for five
seconds. The tape symbol on the display will flash for
two seconds, indicating the feature is active.
4. Insert the adapter into the cassette slot. It will
power up the radio and begin playing.
The override feature will remain active until EJECT is
pressed.
3-66