Chevrolet 2003 Corvette Owner's Manual page 178

Adjusting the Speakers (BallanceIFade)
BAL (Balance): To adjust the balance between the
right and the left speakers, press this knob lightly so it
extends. Turn the knob to move the sound toward
the right or the left speakers.
FADE: To adjust the fade between the front and the
rear speakers, press this knob lightly so it extends. Turn
the knob to move the sound toward the front or the
rear speakers.
Return these knobs to their stored positions when
you're not using them.
Playing a Cassette Tape
Your tape player is built to work best with tapes that are
up to 30 to 45 minutes long on each side. Tapes
longer than that are so thin they may not work well in
this player. If a tape is inserted when the ignition is
on but the radio is off, the tape will begin playing. A tape
symbol is shown in the center of the graphic display
tape symbol w ~ l l be accompanied by a direction
arrow.
While the tape is playing, use the VOL, AUTO TONE,
BAL, FADE, BASS and TREB controls just as you do for
the radio. Other controls may have different functions
when a tape is inserted. The display wiii show the tape
symbol and an arrow to show which side of the tape
is playing.
1:;heze\.fer
E !
tsgn !s i!?serted. !/\!he!?
E!
t q e
IC
=ICtI?IP,
the
If you hear nothing or hear just a garbled sound,
it
may
not be in squarely. Press EJECT to remove the tape
and start over.
The player is able to detect a tight or broken tape, and
will eject the tape. The radio will go back to playing
the last station selected.
The player automatically senses the cassette for metal
or CrO 2 and sets the pre-emphasis. Anytime a tape
is inserted, the top side is selected to play first.
If an error appears on the display, see "Cassette Tape
Messages'' later in this section.
1 PREV (Previous): Your tape must have at least three
seconds of silence between each selection for previous
to work. Press this pushbutton to go to the previous
selection on the tape if the current selection has been
playing for less than eight seconds. If pressed when the
current selection has been playing for more than
eight seconds, it will go to the beginning of the current
selection.
2 PROG (Program): Press this pushbutton to play tne
other side of the tape.
3 NEXT: Your tape must have at least three seconds of
silence between each selection for next to work.
Press this pushbutton to go to the next selection on the
tape. if you
noia
this pushbutton
or press it More
than once, the player will continue moving forward
through the tape.
3-65