Electrolux EDH 97981W User Manual page 20

20 electrolux
Warning! If the appliance was not
transported in an upright position, leave
it to stand for 12 hours before
connecting it to the electricity supply
and using it for the first time, so that
the oil can flow back to the
compressor. Otherwise the
compressor could be damaged.
APPLIANCE POSITIONING
• It is recommended that, for your conven-
ience, the appliance is positioned close
to your washing machine.
• The tumble dryer must be installed in a
clean place, where dirt does not build up.
• Air must be able to circulate freely all
round the appliance. Do not obstruct the
front ventilation grille or the air intake
grilles at the back of the appliance.
• To keep vibration and noise to a mini-
mum when the tumble dryer is in use, it
should be placed on a firm, level surface.
• Once in its permanent operating position,
check that the tumble dryer is absolutely
level with the aid of a spirit level. If it is
not, raise or lower the feet until it is.
• The feet must never be removed. Do not
restrict the floor clearance through deep
pile carpets, strips of wood or similar.
This might cause heat built-up which
would interfere with the operation of the
appliance.
Important!
• The hot air emitted by the tumble dryer
can reach temperatures of up to 60°C.
The appliance must therefore not be in-
stalled on floors which are not resistant to
high temperatures.
• When operating the tumble dryer, the
room temperature must not be lower
than +5°C and higher than +35°C, as it
may affect the performance of the appli-
ance.
• Should the appliance be moved, it must
be transported vertically.
• The appliance must not be installed be-
hind a lockable door, a sliding door a
door with a hinge on the opposite side to
that of the appliance in such a way that a
full opening of the tumble dryer is restric-
ted.
REMOVING TRANSPORT SAFETY
PACKAGING
Caution!
Before use all parts of the transport pack-
aging must be removed.
1. Open loading door
2. Pull off adhesive strips from inside ma-
chine on top of drum.
3. Remove foil hose and polystyrene pad-
ding from the machine.
DRYING RACK UNPACKING
Caution! Before appliance use all
packaging parts and drying rack must
be removed from the drum. The inside
of the drum must be clean.
To unpack the rack:
1 2
4 3