Warnings - Graco Xtreme-Duty Agitator Operation And Parts

Warnings

Warnings
Warnings Warnings
The following warnings are for the setup, use, grounding, maintenance, and repair of this equipment. The
exclamation point symbol alerts you to a general warning and the hazard symbols refer to procedure-specific
risks. When these symbols appear in the body of this manual or on warning labels, refer back to these
Warnings. Product-specific hazard symbols and warnings not covered in this section may appear throughout
the body of this manual where applicable.
FIRE AND FIRE FIRE AND EXPLOSION AND
Flammable fumes, such as solvent and paint fumes, in work
or solvent flowing through the equipment can cause static sparking. To help prevent fire and
explosion:
• Use equipment only in well ventilated area.
• Eliminate all ignition sources; such as pilot lights, cigarettes, portable electric lamps, and
plastic drop cloths (potential static sparking).
• Ground all equipment in the work area. See Grounding
• Never spray or flush solvent at high pressure.
• Keep work area free of debris, including solvent, rags and gasoline.
• Do not plug or unplug power cords, or turn power or light switches on or off when flammable
fumes are present.
• Use only grounded hoses.
• Hold gun firmly to side of grounded pail when triggering into pail. Do not use pail liners unless
they are anti-static or conductive.
• Stop Stop Stop operation operation immediately operation
equipment until you identify and correct the problem.
• Keep a working fire extinguisher in the work area.
PRESSURIZED EQUIPMENT PRESSURIZED PRESSURIZED
Fluid from the equipment, leaks, or ruptured components can splash in the eyes or on skin
and cause serious injury.
• Follow the Pressure
cleaning, checking, or servicing equipment.
• Tighten all fluid connections before operating the equipment.
• Check hoses, tubes, and couplings daily. Replace worn or damaged parts immediately.
MOVING MOVING MOVING PARTS
Moving parts can pinch, cut or amputate fingers and other body parts.
• Keep clear of moving parts.
• Do not operate equipment with protective guards or covers removed.
• Pressurized equipment can start without warning. Before checking, moving, or servicing
equipment, follow the Pressure
4
WARNING
WARNING WARNING
EXPLOSION HAZARD EXPLOSION HAZARD HAZARD
immediately if static sparking occurs or you feel a shock. Do not use immediately
EQUIPMENT HAZARD EQUIPMENT HAZARD HAZARD
Pressure Relief Pressure Relief Procedure Relief Procedure when you stop spraying/dispensing and before Procedure
PARTS PARTS HAZARD HAZARD HAZARD
Pressure Pressure Relief
work area
work
Grounding instructions.
Grounding
Relief Procedure Relief Procedure and disconnect all power sources. Procedure
area can ignite or explode. Paint
area
3A4032B