Table of Contents
Advertisement
Operation
Using the
the Elevator
Elevator
Using
Using
the
Elevator
(included in in in some
some packages)
(included
(included
some
Refer to the Elevators and Pump Supports Manual
306287 for detailed information about using the
elevator.
The elevator air control has three settings: RAISE,
OFF, and RUN.
• RAISE allows the elevator to be raised and
disables the agitator and feed pump air.
• OFF turns off all air pressure. If the elevator is
raised, OFF will lower the elevator.
• RUN enables the agitator and feed pump air.
A restrictor valve on the elevator air line slows the
elevator for safe operation.
Using
Using the
Using
the Agitator
the
Agitator
Agitator
Make sure that the agitator shut-off valve is in the
CLOSED position and the regulator is turned all the
way down.
If used, turn the elevator control to RUN.
Turn the agitator shut-off valve to the OPEN position.
Slowly open the regulator valve to increase agitator
speed until the desired speed is reached.
NOTE:
NOTE:
NOTE: Always maintain moderate agitator speed.
Excessive agitator speed may cause vibration,
foaming of fluid, and increased wear on parts.
14
packages)
packages)
NOTICE
NOTICE
NOTICE
To prevent air motor failure and possible damage
to equipment, always keep the air motor properly
lubricated.
The Xtreme-Duty Agitator is provided with an air
line lubricator to aid in proper maintenance. Fill
the lubricator with SAE #10 light oil and set the
lubricator feed rate at 1 drop of oil per minute
for high speed or continuous duty usage. Do
not overfeed oil or exhaust air may become
contaminated. To manually lubricate the air motor,
see
Lubricating the Agitator Air Motor, page
Using the
the Feed
Feed Pump
Pump
Using
Using
the
Feed
Pump
(included in in in some
some packages)
(included
(included
some
Fluid under high pressure can be injected through
the skin and cause serous injury. To reduce the
risk of an injury from injection, splashing fluid, or
moving parts, follow the Pressure Relief Procedure
whenever you:
• are instructed to relieve the pressure,
• stop spraying,
• check or service any of the system equipment,
• or install or clean the spray tips.
Refer to the feed pump manual and component
manual for any dispense equipment used for specific
operation and pressure relief instructions.
Feed Pump
Pump Pressure
Pressure Relief
Feed
Feed
Pump
Pressure
For feed pump pressure relief information, refer to
the appropriate feed pump manual.
Related Manuals, page 3
15.
packages)
packages)
Relief Procedure
Procedure
Relief
Procedure
.
3A4032B
Advertisement
Table of Contents
