Table of Contents
Advertisement
A fan turning on within the tape drive w ill indicate that the
tape drive is on. T h e lig h t o n th e tape d riv e
w ill n o t
g o o n
u n le ss th e re is a tape ca rtrid g e w ith in th e tape d rive.
Loading and unloading the tape
cartridge
N o te : D O N O T O PEN THE D O O R on the tape drive
unless the light on the front is glowing green (w h en
cartridge is installed but not operating) or when the
light is o ff (n o cartridge is installed). Failure to observe
this precaution may cause data loss.
Loading the tape cartridge into the drive is a simple
operation:
1) Open the fro n t door o f the tape drive by pressing the
eject button on the upper left hand comer.
The door w ill spring halfway open. Gently press down on the
door until it stops.
2 ) Insert the cartridge into the door with the metal side
down and the notches fa cin g to the left.
3 ) Once the cartridge is held in place by the drive
;
push the
door shut.
I f th e tape is in s e rte d in c o rre c tly , th e d o o r w ill n o t
shut. D o n o t fo r c e it.
The cartridge is properly installed if the door shuts fully and a
" click" is heard when the eject button goes back into place.
10
Advertisement
Table of Contents
