HAMPTON BAY HAVANA 48-HVA Use And Care Manual page 10

Assembly - Attaching the Fan Blades
8
Attaching the blades to the blade
brackets
□
Attach a blade (G) to a blade bracket (H) by inserting blade
attachment screws (AA) into the holes in the blade (G) and
through the blade bracket (H). Note that the rubber washers
are preattached to the blade bracket.
□
Tighten each screw securely.
□
Repeat these instructions for each blade (G) and blade
bracket (H).
G AA
H
9
Fastening the blade assemblies to
the motor
WARNING: Remove the rubber motor stops (PP) on the bottom
of the fan before installing the blades or testing the motor.
WARNING: Remove the rubber plug (QQ) on the black bracket
(RR) below the motor in order to attach the blade assembly
to the motor. Replace the rubber plug (QQ) to prevent water
from entering the switch housing and to reduce the risk of fire,
electric shock, or other personal injury.
□
Fasten the blade assembly to the fan-motor assembly (D)
by inserting the alignment post into the slot on the bottom
of the motor and tightening the blade bracket (H) screws.
The blade bracket screws are pre-installed into the blade
bracket (H).
□
Repeat this step for the remaining blade assemblies.
D
PP
RR
10
H
QQ