Chevrolet 1999 S10 Pickup Owner's Manual page 276

One-Piece Front Turn Signal
Lamp Assembly
1. Remove the headlamp assembly as shown under
-
"One Piece Composite Headlamp System" earlier in
this section.
3. Pull the bulb straight out to remove it from the socket.
4. Push the new bulb into the socket until it snaps
into place.
5. Put the bulb socket into the lamp assembly and twist
it clockwise until it is tight.
6. Put the headlamp assembly back into the vehicle.
Install the two retaining clips.
6-38
2. Twist the bulb socket
counterclockwise to
remove it from the
headlamp assembly.
Two-Piece Front Turn Signal
Lamp Assembly
1. Remove the headlamp assembly as shown under
-
"Two Piece Composite Headlamp System" earlier in
this section.
3. Unplug the electrical connector.
2. Locate the locking tabs
on the assembly.
Squeeze the tabs
together and push that
end of the assembly out
while holding the tabs.
The assembly will
swing out.
yellowblue