Advertisement
6.
Adjusting Display Position
6.1
Horizontal Level Adjustments
• You tightened the locking nuts at the bottom of the arm assembly end plate
at the end of the last step. Now loosen them ¼ turn each. This allows you
to position the display with minimal effort.
• Place a level on top of the display, and rotate the display until it is horizontally
level.
• After adjustment is complete, tighten the nuts.
6.2
Vertical Position Adjustments
WARNING: Loosen the vertical shift lock bolts before adjusting the vertical position. Using vertical shift while
lock screws are engaged will damage the height adjustment system.
• Locate the four locking bolts on the sides of the vertical track
down. There are two on each side, all four must be disengaged before adjusting height. They do not need to be
removed.
WARNING: Do not over-drive the height adjustment to its extremes (top or bottom). Doing so will damage the
height adjustment system.
• Locate gear box and
10mm hex gear drive
toward the bottom of
vertical track.
• Use a drill with 10mm hex
socket or provided socket
wrench to adjust. Use
the drill at low speeds
to ensure you do not
damage the system.
• Turn bolt clockwise to
move mount down.
• Turn
bolt
counter-
clockwise
to
move
mount up.
• Once the height is where
you want it, tighten the
locking bolts to secure
the display.
+/- 4°
+/- 10°
Œ
Œ
. Loosen these bolts so the sled can move up and
Œ
leveling nuts
Œ
Œ
Pg. 7
Advertisement
